VWAP Pull-In Quality Gate — Cheatsheet

Source: VWAP_PULL_IN_QUALITY_GATE (full doc) · Diagnostic (data) · Use: Print this. Refer pre-market and before every Pull-In entry.
âš  Mechanism caveat (2026-06-04): The slug vwap-pull-in -> trend is currently outcome-based, not mechanism-confirmed. Read it as "profitable Pull-In with wide exit," NOT automatically as "true trend conversion." First 5-minute post-entry behavior determines management: expansion + slope acceleration = possible trend conversion; flat band + flat slope = rotation scalp; opposite state/slope = wrong-side escape. (audit)

The rule

"Plain VWAP Pull-In is only a clean setup in calm, controlled tape; in hot tape, it must either be managed for trend conversion or be passed."

The Gate

🟢 GREEN — TAKE
RVOL 1.0–1.5 AND gap < 0.5% AND MTF grand > 25
Normal Pull-In allowed. Hold for trend conversion at +2 SD — do NOT scratch at +1 SD.
🟡 YELLOW — CAUTION
RVOL 1.5–2.5 OR gap 0.5–1.5%
Reduced size only. Take ONLY if structure is clean AND you can articulate the trend-conversion thesis BEFORE entry.
🔴 RED — STOP
RVOL > 2.5 OR gap > 1.5% OR symbol in {IBIT, AMD, ETHU, RGTI} OR entry < 10:00 ET in hot tape
Do NOT treat as plain Pull-In. Reclassify (see below) or pass.

Pre-trade checklist — 7 questions

Before clicking buy, answer all 7 out loud:

  1. RVOL? → target 1.0–1.5; >2.5 = STOP
  2. Gap %? → target <0.5%; >1.5% = STOP
  3. First-hour emotional tape? (09–10 ET + hot RVOL = double-strict)
  4. Controlled around VWAP, or hot expansion? (controlled = OK; expansion = manage for trend or pass)
  5. Evidence it can convert to trend? (HH+HL, MTF grand >25, +2 SD reach achievable)
  6. Really a plain Pull-In, or am I chasing? (if you hesitate, you're chasing)
  7. If it fails to convert, where do I exit? (LB1 / VWAP / time stop — pick BEFORE entry)

If you can't answer 1–7 quickly: pass.

If hot tape (🟡/🔴), reclassify as…

What the tape showsReal setup nameDifferent rules
HH+HL after +2 SD close; entering on pullback to +1 SD; VWAP slope risingPull-In → Trend / Trend TradeStop = VWAP, target = +4 SD, hold the core
Extended >2 SD from VWAP avg, no setup, momentum chaseChase / ExtendedNOT an edge (net flat). Pass.
At intraday/HTF range edge, volume building toward edgeRange Break / HitchhikerWait for the break, stop outside the consolidation
Extended ≥2.5 SD BELOW VWAP, double-bottom failure formingRubberband / Backside LongStop = −2 SD band, exit at VWAP, no trailing
Can't honestly name it in calm-tape Pull-In termsPass.The setup doesn't exist on this name today

Rule of thumb: if the only honest label is "I want to be in this stock right now" — that's a chase, not a Pull-In. Pass.

Tomorrow's action rule

  1. Pre-market: list watchlist symbols. For each, note RVOL projection and gap %.
  2. At 09:30 ET: recheck the live RVOL and gap on each watchlist symbol. Any green-tape Pull-Ins?
  3. If GREEN: enter with the trend-conversion management plan (hold for +2 SD, do NOT scratch at +1 SD).
  4. If YELLOW: reduced size, only with clean structure + trend conversion thesis stated out loud.
  5. If RED: do not click "Pull-In." Either reclassify (table above) or pass.

Post-entry management (first 5 minutes — mechanism-aware)

Once in the trade, the first 5 minutes reveal the actual mechanism. Manage to what the tape is doing, not to the slug name:

Symbol watchlist (review before entering plain Pull-In)

These 4 symbols carried −$360 of the −$364 total plain Pull-In loss over the sample window. Treat as RED tape by default; require RVOL <1.5 AND gap <0.5% AND clean conversion thesis before plain Pull-In.

IBIT −$185, 10 trades, 30% WR
AMD −$70, 3 trades, 0% WR
ETHU −$69, 3 trades, 0% WR
RGTI −$36, 2 trades

First-hour warning

09:00–10:00 ET held 91 of 127 plain Pull-In trades and −$401 of P&L in the sample window. Same hour, PI → Trend was +$253 at 100% win rate (n=11). The hour isn't the problem; selection within the hour is. In this window, apply Rule R5: require RVOL <2 AND gap <1%. Otherwise pass.

Links